How to Merge Hardwood Flooring When Removing a Wall. Be sure the sheen of the finish matches the rest of the floor. Patch a Hardwood Floor.
How to Patch a Damaged Hardwood Floor: 1. Steps. 1Determine the size of the pieces you need to replace. Locate a threshold or a heat register and lift it out. Measure the thickness and width of the board. Next measure the length of the piece you want to remove. Visit a lumberyard, home- improvement store, floor- covering store or mill workshop. Buy pieces of wood that match your flooring measurements. You want to buy pieces that are the same width, but they do not have to be the same length, since you will cut them down. The board should be retrofitted with grooves to fit into place in your floor. If not, you will bevel the board using a saw. Research a stain color that will match your floor, at a home improvement store. Test them on scrap boards and compare against your floor. Buy a polyurethane finish. You will stain after the work has been completed. Bore a hole through each end of the damaged board that is about 1 inch (2. Upon installation, tongue and grove hardwood floors are locked into place; this step will allow you to remove them. Using a straight edge, draw lines connecting the right edges of the holes and then connecting the left edges. ![]() Detailed analysis of installing solid hardwood floors. From starting layout to finish. Proper sub floor conditions, tools, underlayment, fasteners, expansion and more is covered. Hardwood Floor Repair: How to Patch a Hardwood Floor. The next step of repairing hardwood floors is the sanding. Before you finish your hardwood floor repair project. This is where you will plunge cut with your circular saw. Take your circular saw and adjust the blade so that the depth of the cut you will make will be equal to the thickness measurement of the boards. Wear eye protection and plug the saw into an outlet. Remove the blade guard, place the nose of the saw down at the top edge of the line. Raise the saw above the floor, turn it on and then cut along the right line. Then, cut along the left line. Use your hammer and chisel to pry out the middle section. Carefully, lop off the remaining edges. You do not want to hit the surrounding floorboards. The tongue section is nailed in place, so you must remove it in small pieces and then use the hammer to remove the nails. Remove any remaining parts of the tongue. This is likely to be the hardest part of the process. Trim a new board using a saw. Measure carefully to make sure it is a perfect rectangle. The tongue will fit into the existing tongue groove. However, the other end will drop into place, rather than fit into the tongue. Remove a section of the groove using your saw or a chisel. Test the board. 1. Use a urethane adhesive on the tongue of the new board and on the tongue and groove of the surrounding boards. Place the new board in the empty space. Tap it into place by using a scrap of wood for protection. Cut a sheet of wax paper and place it above the board, then use heavy books to weight it down. Stain the replacement board until it matches the surrounding boards. Cover with 2 coats of polyurethane varnish using a foam applicator to avoid getting varnish or stain on other floorboards. Some floors may not be stained, but be sure to still cover the board with the varnish to protect it from future damage.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
September 2016
Categories |